Skip to content

June 2026: Sparklers, Green Views, and a Tiny Controller Running the Show

Looking back at my camera roll from June, I’m struck by how much of it is “in between” moments: a receipt here, a motorway hold-up there, a pile of parcels from AliExpress on the desk. But scattered among those are the pictures that actually matter, and this month there were a few good ones.

Life Updates

Celebrating with Sparklers

The month kicked off with a proper night out. A dessert, a sparkler and a very happy face made it easily my favourite photo of June. There’s something about a sparkler on a pudding that instantly turns a normal meal into an occasion.

It was a good reminder that the best evenings are rarely the fancy ones. Good food, people you like, and someone willing to hold a sparkler near a plate of ice cream.

A smiling woman holding a lit sparkler over a dessert at a restaurant table
Sparklers, dessert and a proper celebration

A Breather in the Countryside

Early in the month we managed to get away for a little while, and the view from where we stayed was hard to beat. Rolling fields, a scattering of young trees in their protective guards, and a sky that couldn’t decide between grey and blue. I took the panorama and then just stood there for a bit longer than I needed to.

Working in IT, it’s easy to spend days staring at screens and dashboards. A wide, green horizon is a surprisingly effective reset.

Panoramic view of rolling green countryside with young trees planted in a field under a cloudy blue sky
A view worth pausing for

Back to the Workbench

Of course, it wouldn’t be one of my months without some tinkering. A few more bits arrived for the lighting projects, and the little ESP32 WLED controller below is now the brain behind some of it. Small box, a handful of wires, and a surprising amount of colourful chaos on the other end.

An ESP32 WLED digital LED controller with red and white power wires and blue terminal connectors
The little ESP32 WLED controller doing the heavy lifting

Tech Corner

WLED: Back Up Your Config Before You Tinker

If you run WLED on an ESP32, get into the habit of backing up your setup before changing anything. In the web UI, go to Config → Security & Updates and download both cfg.json and presets.json. Those two files hold your LED layout, GPIO pins, and every preset you’ve lovingly built.

You can also grab them from the command line, which is handy for scripting a regular backup:

curl -o wled-cfg.json http://WLED_IP/cfg.json
curl -o wled-presets.json http://WLED_IP/presets.json

Restoring is just uploading them again after a re-flash, which turns a lost evening into a two-minute job.

Docker: See Where Your Disk Went

Following on from my recent cleanup post, here’s a quick one. Before you prune anything, run:

docker system df -v

It breaks down images, containers and volumes by size, so you can see exactly what’s eating space instead of deleting blindly. Handy on a home lab box where a forgotten container’s volume quietly grows to tens of gigabytes.

Closing Thoughts

June felt like a balance of celebrating, resting and tinkering, which is honestly a pretty good recipe. I’m heading into the rest of the summer with a few half-finished projects and a slightly bigger box of parts than I planned. See you next month.

Published inPersonalWLED

Be First to Comment

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.